![]() ![]() Ensure that connections are secure at the fuel pump and the top cap (2) of the sender assembly. Connect the electrical connector (4) to the fuel pump. Install the fuel pressure regulator in to the fuel filter assembly. Apply gasoline to fuel pressure regulator O-ring (5), and install to the fuel pressure regulator (6). Install the fuel pump (11) in to the fuel filter assembly (13). Apply gasoline to fuel pump O-ring (12), and install to the fuel pump. ![]() Install the fuel pump strainer (7) to the fuel pump (11). Remove the fuel pump (1) from the fuel filter assembly (2)Remove the retaining ring for the fuel strainer from the fuel pump. Disconnect the fuel pump electrical connector. Remove the fuel level sensor (1).Remove the fuel sender top cap (1) from the fuel filter assembly. Disconnect the fuel level sensor electrical connector. Remove the bottom cap (2) and the lower cushion (3) from the fuel sender assembly. Refer to Fuel Sender Assembly Replacement. (Note: thats just to remove the fuel sender to get to the fuel filter)Remove the fuel sender assembly. Inspect and clean O-ring sealing surfaces on the fuel sender assembly. ![]() Remove the fuel sender assembly (4) from the fuel tank. Clean the fuel pipe and the fuel sender assembly to prevent possible fuel contamination during removal. Disconnect the fuel tank vapor line (2) from the fuel sender assembly.Remove the 8 bolts (1) retaining the hold down plate (2) for the fuel sender assembly. Remove the fuel line (3) from the fuel sender assembly. Disconnect the electrical connector of the fuel tank pressure (FTP) sensor (2) from the fuel sender assembly.Remove the retaining clip (1) from the fuel line fitting. Disconnect the fuel sender electrical connector (1) from the fuel sender assembly. The panel is held in place by a butyl caulk seal. Remove the access panel for the fuel sender assembly from the rear seat floor. Fold back the carpet in order to maintain metal-to-metal contact while servicing the fuel sender assembly. Remove the sill plate from the left side door opening. Refer to Seat Cushion Replacement - Rear in Seats. Access is gained from inside the car under the rear passenger seats.Noted by this photo:The Fuel Filter is in the top right of this photo: The following is a step by step provided by Mavrik.Quote, originally posted by Mavrik »Remove the two fasteners and swing the rear seat bottom cushion up and out of the way. I took this from various threads dealing with fuel filter.It should be noted that the design of this system renders this service "NOT NECESSARY" so long as there is not a direct issue.The Fuel Filter is located inside the Tank and it is not necessary to drop the tank. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |